Home Menu

Menu


          
PY Online Forums - Bringing the Pontiac Hobby Together > Search Forums > Search Results
Page 1 of 6 1 23 Last »
Showing results 1 to 25 of 133
Search took 0.05 seconds. Search: Posts Made By: "QUICK-SILVER"
Forum: Pontiac - Race 08-12-2024, 06:24 PM
Replies: 20
Views: 3,027
Posted By "QUICK-SILVER"
Think that valley needs vent tubes so blowby can...

Think that valley needs vent tubes so blowby can come up and out and not be fighting against oil trying to get down.

If oil in the valley got deep enough, I could see blowby shoving oil out the...
Forum: Pontiac - Street 08-12-2024, 04:32 PM
Replies: 39
Views: 1,619
Posted By "QUICK-SILVER"
Hose between pump and 'T' could be sucking air or...

Hose between pump and 'T' could be sucking air or kinked.

Clay
Forum: 66-67 GTO Tempest & LeMans TECH 08-06-2024, 10:30 AM
Replies: 10
Views: 416
Posted By "QUICK-SILVER"
Try wiggling the turn signal lever with left turn...

Try wiggling the turn signal lever with left turn on. If you get a flicker out of right brake the turn signal switch needs some TLC or replaced.

Clay

PS this test should work with ignition...
Forum: THE LOBBY 03-08-2024, 12:54 PM
Replies: 18
Views: 1,733
Posted By "QUICK-SILVER"
Or copper that got mushroomed, cracked and fell...

Or copper that got mushroomed, cracked and fell off.

Clay
Forum: Pontiac - Race 12-11-2023, 10:33 AM
Replies: 12
Views: 729
Posted By "QUICK-SILVER"
Any chance this is an automatic car with a leaky...

Any chance this is an automatic car with a leaky modulator valve?

Clay
Forum: Pontiac - Street 11-20-2023, 01:59 PM
Replies: 62
Views: 7,812
Posted By "QUICK-SILVER"
Both Directions

Only true when intake vacuum is high enough to out run crankcase fumes.

No intake vacuum under heavy load and the crankcase fumes come out the valve cover vent.


Treed by Mick
Clay
Forum: Pontiac - Race 09-10-2023, 01:22 PM
Replies: 30
Views: 2,912
Posted By "QUICK-SILVER"
Don't want to be politically incorrect here......

Don't want to be politically incorrect here... But when did info search and intended use start meaning the same thang?

Asking for a friend
Clay
Forum: Electrical Tech 09-10-2023, 12:38 PM
Replies: 6
Views: 812
Posted By "QUICK-SILVER"
That tells us your feed back problem is in the...

That tells us your feed back problem is in the left rear.
Bad ground, defect bulb, wrong bulb, bulb orientation.. just have to check and see.



Perfectly normal when flashers don't have full...
Forum: 77-81 Firebird & Trans Am TECH 09-08-2023, 10:36 AM
Replies: 5
Views: 625
Posted By "QUICK-SILVER"
Blacked out holes looks way better than brake...

Blacked out holes looks way better than brake dust stains on polished wheels.

Did mine the same way after polishing.
Clay
Forum: Pontiac - Race 09-02-2023, 06:27 AM
Replies: 15
Views: 1,295
Posted By "QUICK-SILVER"
Looks like you can watch it here ...

Looks like you can watch it here

https://www.youtube.com/@MotorManiaTV/streams

Clay
Forum: Pontiac - Street 08-21-2023, 10:08 AM
Replies: 28
Views: 2,598
Posted By "QUICK-SILVER"
Have seen jam nuts on adjustable pushrods work...

Have seen jam nuts on adjustable pushrods work loose.

More you worked the pedal the shorter the rod got.

Eventually getting short enough that the clutch wouldn't disengage.

Clay
Forum: Pontiac - Street 08-18-2023, 11:53 AM
Replies: 28
Views: 2,598
Posted By "QUICK-SILVER"
Should have asked first... Is it using/losing...

Should have asked first... Is it using/losing any fluid?

Clay
Forum: Pontiac - Street 08-18-2023, 11:10 AM
Replies: 28
Views: 2,598
Posted By "QUICK-SILVER"
Plate have its own bolts with big washers on the...

Plate have its own bolts with big washers on the inside?

Clay
Forum: Pontiac - Street 08-10-2023, 11:21 AM
Replies: 121
Views: 10,051
Posted By "QUICK-SILVER"
(or vice versa)? Would be correct. How far the...

(or vice versa)? Would be correct. How far the ring gear rocks up and down.

Yes on setting up the dial indicator.

All should work out the same using the factory cast iron shims.

Clay
Forum: Pontiac - Street 08-09-2023, 02:31 PM
Replies: 121
Views: 10,051
Posted By "QUICK-SILVER"
"gear setup" Would be for new gears or gears with...

"gear setup" Would be for new gears or gears with zero wear. 100K+ gears is gonna have some wear. I wouldn't want to change that wear pattern at all.

To inspect an inner bearing race, the cage...
Forum: Pontiac - Street 08-09-2023, 11:35 AM
Replies: 121
Views: 10,051
Posted By "QUICK-SILVER"
Feel like in my younger daze I could hear and...

Feel like in my younger daze I could hear and feel every tooth of a ring and pinion when they meshed. Wouldn't call it a rumble but definately a noise.

Any slack in bearings, carrier or pinion,...
Forum: Pontiac - Street 08-08-2023, 03:30 PM
Replies: 121
Views: 10,051
Posted By "QUICK-SILVER"
Listening to your video, I would pull the carrier...

Listening to your video, I would pull the carrier and pinion for a bearing inspection.

Never felt any resistance on a pinion if the rearend has miles on it.

Takes a bunch of torque to crush a...
Forum: Pontiac - Street 08-08-2023, 03:18 PM
Replies: 121
Views: 10,051
Posted By "QUICK-SILVER"
Cross shaft should slide out with your fingers...

Cross shaft should slide out with your fingers once the retaining bolt is removed. May require a light tap to get it started out.

Yes to changing them in the car.

Yes to axle gears.

Clay
Forum: THE LOBBY 08-08-2023, 10:36 AM
Replies: 26
Views: 1,765
Posted By "QUICK-SILVER"
Local news here uses a drought monitor to show...

Local news here uses a drought monitor to show how much above average we are on rain fall.

Not sayin' anything else
Clay
Forum: Pontiac - Street 08-04-2023, 10:07 AM
Replies: 16
Views: 1,151
Posted By "QUICK-SILVER"
Yoke slides through a bushing in the tail shaft...

Yoke slides through a bushing in the tail shaft housing. The bushing is replaceable.

Clay
Forum: Pontiac - Street 08-02-2023, 12:57 PM
Replies: 16
Views: 1,151
Posted By "QUICK-SILVER"
Movement between the shaft and yoke says the...

Movement between the shaft and yoke says the joint is worn out or it's the wrong joint for the job.

Clay
Forum: Pontiac - Street 07-27-2023, 10:22 AM
Replies: 26
Views: 2,107
Posted By "QUICK-SILVER"
https://www.facebook.com/brentwilliam.flynn/posts/...

https://www.facebook.com/brentwilliam.flynn/posts/pfbid02DF4GgDxd9K6uWiAdwK7Hk2pCS1R8oh1eJyLUTRMi2oiXDeNChsNn933v11VVeuxml
Forum: THE LOBBY 07-26-2023, 04:02 PM
Replies: 35
Views: 3,249
Posted By "QUICK-SILVER"
Price was 35k at Norwalk. He turned down a 28k...

Price was 35k at Norwalk. He turned down a 28k offer.

Clay
Forum: 77-81 Firebird & Trans Am TECH 07-20-2023, 09:38 AM
Replies: 17
Views: 885
Posted By "QUICK-SILVER"
Tan wire on drivers side door jamb switch is the...

Tan wire on drivers side door jamb switch is the ground for the key buzzer.

Clay
Forum: 70-73 Firebird & TA TECH 07-13-2023, 11:27 AM
Replies: 5,662
Views: 781,647
Posted By "QUICK-SILVER"
Check connections to the modulator valve. Slight...

Check connections to the modulator valve. Slight vaccum leak from a tired rubber hose will do this.

Clay
Showing results 1 to 25 of 133
Page 1 of 6 1 23 Last »

 
Forum Jump

All times are GMT -4. The time now is 05:08 AM.

 

About Us

The PY Online Forums is the largest online gathering of Pontiac enthusiasts anywhere in the world. Founded in 1991, it was also the first online forum for people to gather and talk about their Pontiacs. Since then, it has become the mecca of Pontiac technical data and knowledge that no other place can surpass.

 




Contact Us Home
Copyright © 2017