Home Menu

Menu


          
PY Online Forums - Bringing the Pontiac Hobby Together > Search Forums > Search Results
Page 1 of 12 1 2311 Last »
Showing results 1 to 25 of 290
Search took 0.04 seconds. Search: Posts Made By: 64speed
Forum: Pontiac - Street Today, 02:59 PM
Replies: 7
Views: 57
Posted By steve25
With studs or bolts this is the way I have ...

With studs or bolts this is the way I have always added a bead of sealant and have never had a leak..

All the oil pan bolt holes are blind.
Forum: Pontiac - Street Today, 12:53 PM
Replies: 2,011
Views: 301,108
Posted By HWYSTR455
Those lower shock mount bolts I PM'd a link to...

Those lower shock mount bolts I PM'd a link to you are spaced out by an inch, which helps a lot with exactly the interference you are experiencing.



.
Forum: Pontiac - Street 09-16-2024, 10:09 PM
Replies: 7
Views: 370
Posted By Tim Corcoran
There are builders on this site that I would...

There are builders on this site that I would trust more than an big company like AED. Jim Bollinger built an 800 CFM Q-Jet for me and I am quite happy with it. There are a couple others on the board...
Forum: Pontiac - Street 09-13-2024, 07:18 AM
Replies: 44
Views: 1,291
Posted By Formulajones
For an engine to rise to 250-260 degrees after...

For an engine to rise to 250-260 degrees after shut off I would have to guess driving temps are already pretty damn hot.

At normal temps, where I run my engines anyway, I only see them rise to...
Forum: Pontiac - Street 09-12-2024, 11:47 PM
Replies: 22
Views: 1,073
Posted By NeighborsComplaint
.. or you could just get in the car and drive...

.. or you could just get in the car and drive over to your local O'Reilly's and get a new coupler that fits. I have a Lares couple on mine along with a Jeep Grand Cherokee box. I have nice guick...
Forum: Pontiac - Street 08-28-2024, 12:29 AM
Replies: 47
Views: 2,182
Posted By jhein
That's the source of your stress right there! ...

That's the source of your stress right there! Man, have I felt it. You could correlate my heart rate to my water temp gauge. Test it and see. Maybe (probably) it's fine. If not, you need to...
Forum: Pontiac - Street 08-27-2024, 06:39 PM
Replies: 47
Views: 2,182
Posted By jhein
From what you said, it sounds like you're not...

From what you said, it sounds like you're not worried so much about the 197 temp but more worried about the fact it may keep going up until you overheat. If that's the case, just test it. Get it...
Forum: Pontiac - Street 08-25-2024, 08:43 AM
Replies: 18
Views: 903
Posted By tom s
Those look SOOoo good hanging in the engine...

Those look SOOoo good hanging in the engine compartment,I’ll jump right on it!NOT!
Forum: 64-65 GTO Tempest & LeMans TECH 08-19-2024, 10:47 AM
Replies: 41
Views: 2,164
Posted By b-man
He’s referring to Chad in the 64 wood wheel...

He’s referring to Chad in the 64 wood wheel thread I linked.

After reading through that thread again I can’t agree with the assessment that safety certification was an issue, it was more about...
Forum: Pontiac - Street 08-15-2024, 01:33 PM
Replies: 60
Views: 2,722
Posted By i82much
if you're going new and don't care about the...

if you're going new and don't care about the looks, get a 9 or a 60 ....
Forum: Pontiac - Street 08-11-2024, 06:31 AM
Replies: 2,011
Views: 301,108
Posted By Holeshot71
What was your idle rpm when this was happening?

What was your idle rpm when this was happening?
Forum: Pontiac - Street 08-08-2024, 08:42 PM
Replies: 67
Views: 2,030
Posted By tom s
My clutches help me get my range of motion and...

My clutches help me get my range of motion and strength on the total knee replacement I got last September!Tom
Forum: Pontiac - Street 08-07-2024, 10:08 PM
Replies: 2,011
Views: 301,108
Posted By Baron Von Zeppelin
If you have electric radiator fan (idunno) They...

If you have electric radiator fan (idunno)
They are set to come on and run anytime and all time while a/c is working - in most all passenger cars.
Most have 2 speed fans - and will run on high...
Forum: Pontiac - Street 08-06-2024, 01:38 PM
Replies: 43
Views: 54,272
Posted By dpoltzer
Changed to 10-30

Changed to 10-30 and an AC Delco filter. Oil PSI has dropped by 7-8 psi. Thanks again all for the great input. Dave
Forum: Pontiac - Street 08-06-2024, 10:05 AM
Replies: 67
Views: 2,030
Posted By i82much
I used to go through parts store diaphragm...

I used to go through parts store diaphragm clutches like crazy. Switched to a Hays Borg and Beck and it lasted much longer. But that was the 90's. These days my Ram diaphragm is holding up great,...
Forum: Pontiac - Street 08-05-2024, 08:21 PM
Replies: 67
Views: 2,030
Posted By soupman
I used a modern driveline clutch for my TKX....

I used a modern driveline clutch for my TKX. They, MDL, manufactured thier own clutches, prices where pretty decent, might want to check them out.
Forum: Pontiac - Street 08-04-2024, 08:01 PM
Replies: 65
Views: 3,312
Posted By Schurkey
I haven't dicked with points in thirty-plus...

I haven't dicked with points in thirty-plus years. I'm amazed that they're getting good press here. I was DONE with points when the HEIs showed-up in the Treasure Yards.

HEI is THE most-reliable...
Forum: Pontiac - Street 08-04-2024, 01:35 PM
Replies: 65
Views: 3,312
Posted By i82much
I would use a ready to run to trigger an MSD box....

I would use a ready to run to trigger an MSD box. If the MSD box fails on the road, you can rewire to run the ignition using the internal module. Keep two extra coils, an extra MSD box, a points...
Forum: Pontiac - Street 07-31-2024, 11:07 AM
Replies: 43
Views: 54,272
Posted By Formulajones
I would disagree in that area. Just because a...

I would disagree in that area. Just because a classic car engine has a roller doesn't mean you should just run any oil off the shelf.

There are plenty of high pressure areas in the engine that can...
Forum: Pontiac - Street 07-28-2024, 09:23 AM
Replies: 43
Views: 54,272
Posted By Formulajones
I never even bothered with drilling the hole to...

I never even bothered with drilling the hole to lube the distributor gear on any of my builds, including my daily driven RAIII bird I mentioned above. I've racked up over 100k miles on that thing in...
Forum: Pontiac - Street 07-27-2024, 09:38 PM
Replies: 43
Views: 54,272
Posted By Formulajones
I wouldn't worry about it. My RAIII also has 80...

I wouldn't worry about it. My RAIII also has 80 psi cold. A warm idle, not super hot oil, is around 60, but touch the gas it's close to 80. Now if I cruise the highway for an hour and get the oil...
Forum: Pontiac - Street 07-27-2024, 11:04 AM
Replies: 20
Views: 5,983
Posted By PAUL K
On my 80 TA I've went back and forth with a few...

On my 80 TA I've went back and forth with a few factory clutch fans and a factory flex fan. For wherever the reason all the clutch fans would let the temperature rise when caught in traffic. The flex...
Forum: Pontiac - Street 07-26-2024, 06:50 AM
Replies: 20
Views: 5,983
Posted By PunchT37
I ran a flex fan off a `69 Judge [still have it]...

I ran a flex fan off a `69 Judge [still have it] for many years on a 480`ish hp 455. No problems down here in south Louisiana. BUT, I found out the judge had a smaller crank pulley than an a/c car....
Forum: Pontiac - Street 07-24-2024, 08:12 PM
Replies: 13
Views: 594
Posted By RocktimusPryme
I understand what you are saying but I still...

I understand what you are saying but I still think I would go with the solid U joint. I dont understand the argument against. Very few of us drive the cars in anything that would amount to enough...
Forum: Pontiac - Street 07-23-2024, 12:01 PM
Replies: 13
Views: 594
Posted By tooski
On my 68 350/350 both U joints were/are the same....

On my 68 350/350 both U joints were/are the same. 1310 series. I'd be surprised if the U joints were different. I doubt that they would be different from the factory. If they are different the yoke...
Showing results 1 to 25 of 290
Page 1 of 12 1 2311 Last »

 
Forum Jump

All times are GMT -4. The time now is 03:08 PM.

 

About Us

The PY Online Forums is the largest online gathering of Pontiac enthusiasts anywhere in the world. Founded in 1991, it was also the first online forum for people to gather and talk about their Pontiacs. Since then, it has become the mecca of Pontiac technical data and knowledge that no other place can surpass.

 




Contact Us Home
Copyright © 2017