Engine turned dash, Help needed
1 Attachment(s)
So I got my engine turned dash and console inserts and everything lines up EXCEPT the insert for the dash. It hangs over the dash at the bottom by at least an inch. Is this by design? Am I supposed to trim this? and how can I get a clean straight line if I need to trim it? Pics below.
|
1 Attachment(s)
part number correct? for a 1970?
|
I'm sure you have to trim it. You realize that's not a factory decal right?
That's not supposed to be there. |
It looks like they used the original woodgrain applique as a template for this custom piece you have. The woodgrain wraps under the lower part of the bezel, if this part you have doesn't bend you'll have to cut it to fit.
|
It would be nice to have something that tells you that, some kind of instruction sheet? photos? something. Hopefully the tech support guys will see this and give me some direction?
|
You may get a faster response by calling Ames and asking for technical support.
|
Quote:
|
Quote:
|
Quote:
|
All times are GMT -4. The time now is 12:08 PM. |