Intense Racing Cubby Pod
 

Step 1.
Pull the bottom right corner of the Radio towards you. You may need to pull hard as they tend to get stuck.

Step 2.
After Radio cover is off you will see (2) philips screws. These are what the mount will be screwed too.
http://i166.photobucket.com/albums/u...psb72a2744.jpg

Step 3.
Place gauge mount in place in-front over to make sure fitment & holes line up.
http://i166.photobucket.com/albums/u...ps965e68b6.jpg

Step 4.
Remove all T20 torx head screws from silver cover and place gauge mount BEHIND this cover. Then place all screws back in normal location. (make sure to not over tighten)
http://i166.photobucket.com/albums/u...ps56788cc8.jpg

Step 5.
Place radio cover back on silver backing and enjoy your new gauge mount.
http://i166.photobucket.com/albums/u...ps08a7aaeb.jpg
http://i166.photobucket.com/albums/u...ps11b696eb.jpg

Never seen this. Pretty neat. I'll look into getting in touch with these guys and see if we can offer them.