Rear package tray,install with rollbar
 

Trying to figure out how to do a clean package tray install with rollbar.I have a new one but started making a template out of cardboard.I cut it in line with the bar then made holes for the bar.If I did it this way,i need some type of finish material to hide the cut and go around the bar to hide my cut around it.what would be that material be?got any ideas?sorry for the upside down pics.

Not sure, but if I was going to tease a cut I would do it on the other side of the roll bar. I think it would be much less noticeable under those bars

Update on package tray.I cut it inline with both bars and found some flexible trim that had 3M double sided tape on it.covered my cuts up and it doesn't look too bad.then Iput the rest of my interior back together.don't know how to turn these damn pictures upright.