I am looking for the rubber(ish) o-ring/gasket between the fuel tank and fuel nozzle for the rear facing 63 lemans gas tank.
Does anyone have one or a source for a substitute? |
Mike,,, good talking with you the other day & good to see the LeMans! Someone here should have what you are looking for
|
For what it's worth, I posted an introduction in the "projects" thread with pictures of the car, but the post is waiting for an admin to approve it. That has been over a week ago. Does this usually take this long?
|
I think the O rings is same as early chevy?Tom
|
Looking for a convertible top switch for a 63. Thanks Jim
|
switch
I have a vert. top switch for sale. $75 plus $5.80 shipping.
|
PM sent
|
1962 dash trim Part # 4861989. Needs to be real nice condition.
|
4 cylinder camshaft
Looking for a good 4bbl 4 cylinder camshaft for a 62. Can be a 2bbl that I can send it out for a regrind if the price is good.
|
Did you get my pm about that rear view mirror?
|
i sent a guy an email on a convt rv mirror. let me know if its one u need - if I dont hear back in a few days - Ill offer it up again.
pics i can send from my phone - using GFs comp atm.... |
Front Sway Bar Bushing Bracket
Just in case someone has a spare or a set of front sway bar bushing brackets laying around and not planning to use after a conversion. One of mine on the 1963 was rotted beyond repair. Thanks.
|
63 Automatic tran pan gasket
I need a tranny pan gasket for my 63 - 336. Every supplier I have contacted says they only have a 14 bolt gasket where the 63 is a 16 bolt. Does anyone have a supplier for this gaskets. Thanks
|
gaskets
|
Could always buy some gasket material and make one.
|
Quote:
|
Now here is an odd request on a hot summer day. I am after a heater motor for a '63. The number on it is 5044331 and probably spans other years and maybe other GM makes. Mine has seized. Anybody have one laying around after a heater delete?
|
Quote:
|
Hey Dave. I thought you might come through with one. I might have to take you up on that. Obviously I don't need it yet. I have a buddy who works in a rewind shop and he is going to take a look to see if he can loosen it up. He figures it might be the brushes. It hums but doesn't spin.
|
Quote:
|
All times are GMT -4. The time now is 10:33 AM. |