Forum: Pontiac - Street
07-15-2019, 05:45 PM
|
Replies: 0
Views: 1,381
|
Forum: Pontiac - Street
08-12-2018, 10:13 PM
|
Replies: 23
Views: 1,434
|
Forum: Pontiac - Street
08-12-2018, 09:55 PM
|
Replies: 23
Views: 1,434
I think I will pull the shifter apart and place...
I think I will pull the shifter apart and place the reverse shift lever in place and see if I can push the pin in enough to enough to engage the reverse lever. If it wont push in enough to engage the...
|
Forum: Pontiac - Street
08-12-2018, 08:17 PM
|
Replies: 23
Views: 1,434
Correct me if I am wrong. The 3rd and 4th gear...
Correct me if I am wrong. The 3rd and 4th gear shifter arm normally sits in the mushroom shaped pin that sits in the notch on the shifter. When you pull the shifter to the left to go into 1st or 2nd...
|
Forum: Pontiac - Street
08-12-2018, 07:25 PM
|
Replies: 23
Views: 1,434
I took to make sure all the shims and shift...
I took to make sure all the shims and shift levers out it again to make sure they were in correctly and every thing was fine. The 2 springs look to be in correct. The smaller diameter spring goes...
|
Forum: Pontiac - Street
08-12-2018, 05:10 PM
|
Replies: 23
Views: 1,434
|
Forum: Pontiac - Street
08-12-2018, 03:15 PM
|
Replies: 23
Views: 1,434
|
Forum: Pontiac - Street
08-12-2018, 12:03 AM
|
Replies: 23
Views: 1,434
|
Forum: Pontiac - Street
08-11-2018, 01:59 PM
|
Replies: 23
Views: 1,434
It is a used shifter that I got from a friend....
It is a used shifter that I got from a friend. The shifter would not go into reverse before I took it apart to clean it. I cleaned up the area where to spring are at. Pt reverse pen in place. The...
|
Forum: Pontiac - Street
08-11-2018, 08:53 AM
|
Replies: 23
Views: 1,434
Everything is adjusted and 1st thru 4th works...
Everything is adjusted and 1st thru 4th works good. The problem is the shifter will not go into reverse, with or without the linkage hooked up. When I pull the shifter to the left and up, the only...
|
Forum: Pontiac - Street
08-11-2018, 12:09 AM
|
Replies: 23
Views: 1,434
|
Forum: Pontiac - Street
08-08-2018, 11:19 PM
|
Replies: 1
Views: 365
|
Forum: Pontiac - Street
08-08-2018, 10:50 PM
|
Replies: 1
Views: 365
hurst competition plus 4 speed questions
Can any one tell me what this part is and what it does?. The part is rectangular with a slot on both ends that goes on the 2 tabs at the top of the shifter body and it has bolt that goes through the...
|
Forum: 61-77 GTO, Tempest & LeMans Parts WANTED
07-31-2018, 04:45 PM
|
Replies: 1
Views: 57
3 speed muncie bearing retainer
Looking for a bearing retainer for a 3 speed Muncie. Posted this once before but it gives an error message when you click on it
|
Forum: 61-77 GTO, Tempest & LeMans Parts WANTED
07-30-2018, 08:19 PM
|
Replies: 1
Views: 63
|
Forum: Pontiac - Street
07-28-2018, 01:48 PM
|
Replies: 0
Views: 438
help identifying transmission
I know its a 3 speed. The metal tag is located at bottom of cover plate 952657rm. GM1 3887848 on right side of case, bearing retainer has the number 3811877. it has the number HTH14b, tail shaft...
|
Forum: The Body Shop TECH
07-27-2018, 10:53 PM
|
Replies: 19
Views: 642
|
Forum: Pontiac - Street
07-21-2018, 05:49 PM
|
Replies: 15
Views: 1,489
loose pilot bearing
The pilot bearing on my 66 Lemans came apart and destroyed my clutch. I thought it went in to easy. I bought a new pilot bearing and I can put it in with finger pressure. I am worried that the same...
|
Forum: Pontiac - Race
06-11-2018, 01:29 PM
|
Replies: 5
Views: 462
326 ring gaps
I am in the process of putting my 326 back together. The cylinders have been bored 40 over. Will the ring gap be the same as stock? I have new pistons. If not the same, how do I find the correct gap.
|
Forum: Electrical Tech
11-12-2017, 04:51 PM
|
Replies: 9
Views: 431
I unplugged the red wire on the alternator that...
I unplugged the red wire on the alternator that goes to the voltage regulator and no spark when I remove the positive battery lead. What does that mean? I took the alternator and had it tested and it...
|
Forum: Electrical Tech
10-19-2017, 08:27 PM
|
Replies: 9
Views: 431
|
Forum: Heating & Cooling TECH
10-14-2017, 09:44 AM
|
Replies: 6
Views: 454
|
Forum: Heating & Cooling TECH
10-13-2017, 10:27 PM
|
Replies: 6
Views: 454
|
Forum: Heating & Cooling TECH
10-13-2017, 09:31 PM
|
Replies: 6
Views: 454
cooling fan problem
Both of my cooling fans have stopped working today. I checked out every thing including jumping both fans to 12 volts and nothing works. The fans have very little use since I installed them. Has any...
|
Forum: Heating & Cooling TECH
09-28-2017, 05:37 PM
|
Replies: 5
Views: 574
|