Showing results 1 to 25 of 500
Search took 0.06 seconds.
Search: Posts Made By: beemergary
Forum: THE LOBBY Yesterday, 10:31 PM
Replies: 36
Views: 735
Posted By beemergary
At 90 my dad couldn't pass a driving test. Just...

At 90 my dad couldn't pass a driving test. Just took his car away before he killed himself or someone else because he would just drive anyway. Went to the dr. one day just to show him he can do what...
Forum: Pontiac - Race 03-22-2024, 04:57 PM
Replies: 8
Views: 297
Posted By beemergary
I broke my crank and on tear down had two spun...

I broke my crank and on tear down had two spun mains and the tomahawk windage tray was cracked in lots of spaces. Had about 400 runs. Was a moroso pan but had to put around 9+qts. to read full on dip...
Forum: Pontiac - Race 03-22-2024, 01:13 PM
Replies: 8
Views: 297
Posted By beemergary
oil level in relation crank windage tray?

Putting new engine together and taking measurements according to dipstick oil was above windage tray and into crank. Thanks
Forum: Pontiac - Race 03-05-2024, 11:58 PM
Replies: 21
Views: 986
Posted By beemergary
Picking up my new shortblock from machine shop...

Picking up my new shortblock from machine shop tomorrow. He suggested BradPenn. I'll ask the weight.
Forum: 61-63 Tempest & LeMans TECH 02-27-2024, 08:26 PM
Replies: 7
Views: 425
Posted By beemergary
I've did a 63 with an automatic and a 61 wagon...

I've did a 63 with an automatic and a 61 wagon stick. Like Tom S. says. Use a Ford 9" and narrow it or have Moser make one. You can just move the tunnel over 2" for the driveshaft. My 63 rear is a...
Forum: THE LOBBY 02-25-2024, 07:18 PM
Replies: 20
Views: 1,627
Posted By beemergary
Red flag on a wanted post and you get a pm not a...

Red flag on a wanted post and you get a pm not a reply. Then you see they just joined py to send the pm.
Forum: Members Helping Members 02-22-2024, 10:53 PM
Replies: 6
Views: 378
Posted By beemergary
Checked pressure and was down so replaced pump. I...

Checked pressure and was down so replaced pump. I have a return line and no check valve in pump. Fixed problem. Glad it wasn't a leak in the supply line that's 3 feet under ground.
Forum: Members Helping Members 02-11-2024, 12:47 AM
Replies: 6
Views: 378
Posted By beemergary
Did that. Think my photo cell takes 45 sec. to...

Did that. Think my photo cell takes 45 sec. to not see light and then sends signal to the brain box which shuts down furnace and needs a reset button pushed. Thanks
Forum: Members Helping Members 02-10-2024, 10:15 PM
Replies: 6
Views: 378
Posted By beemergary
fuel oil furnace gremlin

Furnace lights and about 8 seconds later goes out and about 3 seconds later comes back on and everything is normal. Earlier there was a contact problem between transformer springs and electrodes but...
Forum: THE LOBBY 12-21-2023, 01:04 AM
Replies: 88
Views: 8,215
Posted By beemergary
Use fresh fuel. Drain and refill filter housing....

Use fresh fuel. Drain and refill filter housing. Make sure rack is not stuck. Crack all injector lines to make sure getting fuel. My 1984 Peterbilt with a Cat 3406b had sat in a barn for 12 yrs....
Forum: THE LOBBY 12-17-2023, 11:22 PM
Replies: 50
Views: 5,872
Posted By beemergary
Got out of Harley's Sportster at 21 yrs. old and...

Got out of Harley's Sportster at 21 yrs. old and got back in at 65 yrs. and I am pushing 74 yrs. now. Son picked up a 1969 xlch sportster that we restored and I have like I had in my day. A real...
Forum: Pontiac - Race 12-11-2023, 11:05 PM
Replies: 8
Views: 889
Posted By beemergary
When first gear is lower your second is also in...

When first gear is lower your second is also in my th400 and the pinions are square cut. Its makes alittle noise but not really noticed.
Forum: Pontiac - Race 12-10-2023, 10:34 PM
Replies: 14
Views: 1,142
Posted By beemergary
My 63 tempest @ 3450# with me will run 11.30's....

My 63 tempest @ 3450# with me will run 11.30's. 980 heads-859 2x4 with 750 eddies-solid roller-3.90 gears-26" tires-4" stock crank-th400.
Forum: Pontiac - Race 12-10-2023, 10:29 PM
Replies: 14
Views: 1,142
Posted By beemergary
My 63 Tempest-3450# with me . 980 heads-859 with...

My 63 Tempest-3450# with me . 980 heads-859 with 750 eddies-th400-390 gears and 26" tires solid roller with good weather runs 11.30's.
Forum: Pontiac - Street 12-09-2023, 11:49 PM
Replies: 6
Views: 625
Posted By beemergary
That's something they could of did before going...

That's something they could of did before going to a plastic restrictor in the rubber hose. I have the plastic one.
Forum: THE LOBBY 12-07-2023, 10:58 PM
Replies: 14
Views: 995
Posted By beemergary
Like other wars and conflicts more than likely...

Like other wars and conflicts more than likely could have been prevented.
Forum: Pontiac - Race 12-05-2023, 01:05 AM
Replies: 29
Views: 1,903
Posted By beemergary
Some may pull to much to begin with. Start out...

Some may pull to much to begin with. Start out with a really small vent hole in back of valve cover.
Forum: Pontiac - Race 11-27-2023, 10:41 PM
Replies: 1
Views: 319
Posted By beemergary
I use hooker d port 68 gto on my 421sd's in my 63...

I use hooker d port 68 gto on my 421sd's in my 63 coupe and 61 wagon.
Forum: THE LOBBY 11-18-2023, 10:04 PM
Replies: 15
Views: 884
Posted By beemergary
Put out a wanted add for a 421 block. Got a...

Put out a wanted add for a 421 block. Got a private message from an Alexanderson who said contact my uncle. Seen he just joined py and his so called uncle sent me some magazine pics. Wanted to use...
Forum: Members Helping Members 09-23-2023, 05:58 PM
Replies: 2
Views: 535
Posted By beemergary
If someone answers a wanted ad look to see when...

If someone answers a wanted ad look to see when they became a py member. Usually the same day. Red Flag
Forum: Big Pontiac(incl G-body)Parts WANTED 09-16-2023, 07:31 PM
Replies: 0
Views: 423
Posted By beemergary
421 block wanted

Good rebuildable starter on block prefered. Thanks Gary Beemer 688 2182 Mi.
Forum: 61-77 GTO, Tempest & LeMans Parts WANTED 09-16-2023, 07:28 PM
Replies: 1
Views: 252
Posted By beemergary
421 block wanted

Good rebuildable starter on block. Gary Beemer 810 6882182 Mi.
Forum: THE LOBBY 09-14-2023, 10:47 PM
Replies: 65
Views: 3,070
Posted By beemergary
When the going gets tough the tough get going....

When the going gets tough the tough get going. Rock On
Forum: SOLD Parts 09-13-2023, 09:28 PM
Replies: 17
Views: 2,879
Posted By beemergary
I just need a 421 assembled block. Good luck

I just need a 421 assembled block. Good luck
Forum: THE LOBBY 09-11-2023, 10:09 PM
Replies: 10
Views: 709
Posted By beemergary
I have a yh. 2 bolt caps but drilled and tap for...

I have a yh. 2 bolt caps but drilled and tap for 4.
Showing results 1 to 25 of 500

 
Forum Jump

All times are GMT -4. The time now is 05:05 PM.

 

About Us

The PY Online Forums is the largest online gathering of Pontiac enthusiasts anywhere in the world. Founded in 1991, it was also the first online forum for people to gather and talk about their Pontiacs. Since then, it has become the mecca of Pontiac technical data and knowledge that no other place can surpass.

 




Copyright © 2017