Home Menu

Menu


          
PY Online Forums - Bringing the Pontiac Hobby Together > Search Forums > Search Results
Page 1 of 20 1 2311 Last »
Showing results 1 to 25 of 500
Search took 0.12 seconds. Search: Posts Made By: ta man
Forum: Pontiac - Street Yesterday, 07:11 AM
Replies: 12
Views: 242
Posted By ta man
I just swapped over to a Derale dual fan setup...

I just swapped over to a Derale dual fan setup with a shroud. They use Spal fans. I'm controlling the fans with a DC control PWM control module. I'm thinking this setup with my new Cold Case rad...
Forum: Pontiac - Street 04-12-2024, 12:23 PM
Replies: 30
Views: 894
Posted By ta man
When I go to the dragstrip I just set the timing...

When I go to the dragstrip I just set the timing fixed, I also use the same table for cold starts. The start retard is also a great feature.
Forum: Pontiac - Street 04-11-2024, 10:09 PM
Replies: 30
Views: 894
Posted By ta man
Its really easy on a phone to see and use, a...

Its really easy on a phone to see and use, a tablet will work as well I have one in my car, another thing to mention is the gauge readout on it shows engine vacuum current timing rpms and mph, as far...
Forum: Pontiac - Street 04-10-2024, 12:22 PM
Replies: 30
Views: 894
Posted By ta man
What I like with mine is I removed the MSD box...

What I like with mine is I removed the MSD box and separate coil..with zero loss in performance. Great for tuning at the track..no wrenches neeeded,timing lights etc..don't even open the hood.
Forum: Pontiac - Street 04-09-2024, 08:29 PM
Replies: 30
Views: 894
Posted By ta man
Check out Progression Ignition.ditch the MSD..I...

Check out Progression Ignition.ditch the MSD..I have one..wish they were out years ago..Rev limiter..adjustable timing curves..start retard..
Forum: Pontiac - Street 04-09-2024, 12:19 PM
Replies: 91
Views: 3,852
Posted By ta man
Yes for sure..it was a tough decision to go away...

Yes for sure..it was a tough decision to go away from a clutch fan and my trusty rad. The shroud does have the air flaps and the fans are rated at 4000cfm, I'm also using a Delta Control PWM ....
Forum: Pontiac - Street 04-09-2024, 07:09 AM
Replies: 91
Views: 3,852
Posted By ta man
It will most likely be mid summer before the...

It will most likely be mid summer before the intake swap test at the dragstrip. I just installed Wilwood Dynalite Pro Series front brakes which dropped 12 lbs off the rotor/hub assembly on each side....
Forum: Pontiac - Street 04-06-2024, 11:06 AM
Replies: 22
Views: 832
Posted By ta man
Do some research before ordering your...

Do some research before ordering your headers..Many members on this forum are owed either a finished product or their money back from Tribal Tubes.
Forum: Interior TECH 04-05-2024, 06:08 PM
Replies: 16
Views: 422
Posted By ta man
How close is the nearest supplier ?

How close is the nearest supplier ?
Forum: Pontiac - Street 04-03-2024, 01:09 PM
Replies: 23
Views: 625
Posted By ta man
Romac

Romac
Forum: Pontiac - Street 03-29-2024, 09:31 AM
Replies: 26
Views: 950
Posted By ta man
Does it go straight under full traction? With my...

Does it go straight under full traction? With my car I try to avoid burnouts on the street..it can get out of shape real quick..at the track a nice controlled burnout for a short distance can even go...
Forum: Exhaust TECH 03-28-2024, 06:51 AM
Replies: 7
Views: 986
Posted By ta man
Basically the same but half the weight of the...

Basically the same but half the weight of the Ultraflows..the Ultraflows are built heavy and last..the fiberglass packing may move around after years but they last forever.
Forum: Pontiac - Street 03-28-2024, 06:47 AM
Replies: 66
Views: 1,699
Posted By ta man
I see this all the time at the dragstrip,guys...

I see this all the time at the dragstrip,guys will show up with really nice builds, big engines ,500 cubic inch plus..and you watch them run down the track and they fall on their face. A/F or fuel...
Forum: Heating & Cooling TECH 03-26-2024, 04:49 PM
Replies: 7
Views: 275
Posted By ta man
That will get going until I buy or make something.

That will get going until I buy or make something.
Forum: Heating & Cooling TECH 03-25-2024, 12:37 PM
Replies: 7
Views: 275
Posted By ta man
Something similar to that Summit part but would...

Something similar to that Summit part but would like four holes in the factory location.
Forum: Heating & Cooling TECH 03-25-2024, 12:35 PM
Replies: 7
Views: 275
Posted By ta man
I was going to ..but looked at the cost of a pump...

I was going to ..but looked at the cost of a pump and a new belt setup..too pricey for now. Maybe if I start racing more.
Forum: Heating & Cooling TECH 03-25-2024, 12:33 PM
Replies: 7
Views: 275
Posted By ta man
I have a Derale setup with the flaps 16927. ...

I have a Derale setup with the flaps 16927.
https://www.summitracing.com/parts/der-16927
Forum: Heating & Cooling TECH 03-24-2024, 11:48 AM
Replies: 7
Views: 275
Posted By ta man
Aftermarket Top Rad Hold down

I'm going from mechanical fan to electric fans with a shroud. Looking for a supplier that sells a top plate that holds down the rad. I've seen them before somewhere.
Forum: Pontiac - Race 03-19-2024, 07:11 AM
Replies: 14
Views: 716
Posted By ta man
Have you contacted Harland Sharp for replacement...

Have you contacted Harland Sharp for replacement rockers?
Forum: Pontiac - Race 03-18-2024, 07:09 AM
Replies: 53
Views: 1,671
Posted By ta man
Have fun testing at the track its a great hobby,...

Have fun testing at the track its a great hobby, like others have said one change at a time and test. My old combo I had in my car I started at low 12's/114 and eventually ran 10.96 at 123..with the...
Forum: Pontiac - Race 03-17-2024, 08:54 AM
Replies: 53
Views: 1,671
Posted By ta man
Engine combination should have you in the 120's...

Engine combination should have you in the 120's for mph..exhaust is too small need 3 inch, is your convertor slipping? Is the total timing optimized? Lots left in the combo..a few things are just...
Forum: Pontiac - Street 03-10-2024, 05:01 PM
Replies: 33
Views: 1,103
Posted By ta man
Sure you can,it's not the old days! You will get...

Sure you can,it's not the old days! You will get a hundred different opinions on cam choice..but the simple solution is go on the Butler site and pick another that has exactly the same valve...
Forum: Pontiac - Street 03-10-2024, 03:21 PM
Replies: 33
Views: 1,103
Posted By ta man
After rereading the OP posts,Family cruiser, run...

After rereading the OP posts,Family cruiser, run mid 11's and the wife drive it are the goals. I think the cam choice and compression ratio is key. The present combo may not like to run at 60mph in...
Forum: Pontiac - Street 03-10-2024, 02:43 PM
Replies: 33
Views: 1,103
Posted By ta man
I would have backed off on the duration to...

I would have backed off on the duration to something like a 235/245 and in the 650 lift range. Would make the car more driveable. As far as the trans a well built 200r4 may last..a friend of mine...
Forum: Pontiac - Street 03-09-2024, 09:33 AM
Replies: 16
Views: 1,000
Posted By ta man
I make sure my engine is warmed up ,pull all the...

I make sure my engine is warmed up ,pull all the plugs,open the throttle fully. One thing that I do on all my Pontiac engines is have an underhood connection on the keyed starter wire that I...
Showing results 1 to 25 of 500
Page 1 of 20 1 2311 Last »

 
Forum Jump

All times are GMT -4. The time now is 06:56 PM.

 

About Us

The PY Online Forums is the largest online gathering of Pontiac enthusiasts anywhere in the world. Founded in 1991, it was also the first online forum for people to gather and talk about their Pontiacs. Since then, it has become the mecca of Pontiac technical data and knowledge that no other place can surpass.

 




Contact Us Home
Copyright © 2017