well i expected the psi to be close to that since the cam is straight up. i was closer to 215 with this cam advaced 4 degrees in a previous engine. i am afraid to advance this cam back to 4 degrees because of the issue i had with pump gas when i used this cam before.
i will be tearing down the carb and making sure it isnt clogged anywhere.
again, is there any issue with having alot of endplay on my distributor?
this weekend i will probably throw a pertronics module (to match the coil) decent plug wires and some plugs at this.
any suggestions on a set of good plug wires at a decent price?
p.s. the lash was set as per the card.
__________________
![Drive](images/smilies/drive.gif) Old enough to know better, but still too young to care.
|