[AdamIsAdam]

Originally Posted by John62

For the third and last time, pull that water pump. The cast impeller shown in your picture is all you need. Use that pump if good, unless your current pump also has that impeller. Throw those divider plates in the trash. Get a new correct set from inline tube. Place the new divider plate on the pump and slowly work your way around the hole with a hammer or other tool till it almost touches, closer the better. Your old pump comes off with just the 8 bolts in the front. 3 are studs and must go in the same spot if the entire stud comes out and use some tape or dope as these 3 studs go into the water. Show us before and after and then go from there.

ok. I'll do pull the pump. Not this weekend, but soon. Where are the backing divider plates on inline tube's site? I don't see them? Why not use the one that's on the car now?