I found out too late that mine was "off" as it was already painted and was during the panel alignment that I figured it out.
I ended up enlarging the bolt holes at the bottom corners for the lower fender brackets as well as the bottom rad support mounts and lower valance panel and shifted everything around so most things are "half wrong" rather than anything being really noticeable.
Again, these things are a total POS that take a lot of work to make close to right. It is good these things are available but as others have said, they should come with a disclaimer and instructions on all the work required to get them correct.
__________________
Michael
1970 Oshawa built 1 option Judge. 24 year restoration/upgrade project finally finished!
1979 Trans Am - low-buck drag car project for when I retire