The engine build was "high end" and overall not all that badly done. They made a couple of small mistakes that doomed it from the beginning.
The used lash caps on the valves, one was "soft" and got ground up to nothing putting metal thru the entire assembly. Two more were missing from the tops of the valves and loose in the assembly, not sure how that happened there?
The big showstopper were the "old school" forged/domed pistons, which require quite a bit of clearance as they are older alloys. They were too tight and two grabbed the cylinder walls destroying the pistons and tearing the bores up pretty hard.
I didn't cc the heads but it should be around 8.8 or so compression, it could go a little higher than that as they were previously milled and we had to cut them again to clean them up.
The cam is a custom ground HR, 281/287, 230/236 @ .050 on a 112LSA. Lift with the rockers we're running will be close to .580/590"......Cliff
__________________
If you can read this, thank a teacher. If you can read this in English, thank a Veteran!
https://cliffshighperformance.com/
73 Ventura, SOLD 455, 3740lbs, 11.30's at 120mph, 1977 Pontiac Q-jet, HO intake, HEI, 10" converter, 3.42 gears, DOT's, 7.20's at 96mph and still WAY under the roll bar rule. Best ET to date 7.18 at 97MPH (1/8th mile),
|