View Single Post
  #25  
Old 11-18-2018, 04:56 PM
rohrt rohrt is offline
Ultimate Warrior
 
Join Date: May 2004
Location: Cedar Rapids, IA
Posts: 4,125
Default

Wow nice work pulling them all apart like that.

Could I have you measure the width of the seatbacks top and bottom from edge wire to edge wire. I'm either getting 22.5 or 23 its hard to tell with the edge wire complete rusted away.

I would gladly swap seats with ya. You got it easy if all you need to do is weld the frame back together.




So the back of my hinge covers look like yours. Where the push pin goes in I don't see any lip. How secure is that pin? I was thinking of maybe just using a plastic push bolt you can kind of see in the background. Does the seat fabric cover some the hing so it wont pop off???



I spent a couple hours trying to recreate this thing. No idea how it really helps but there must be a reason.



I bent out my lower edge wire. I sure hope i'm close enough on the measurements. Thus why I was asking about the measurements.



Here is the big question. Does your seat have the seat belt listings??? I'm thinking they have to come through like this but I don't see any screws for them to attach to..



I made my own spring benders verses spending another $60 for them.