View Single Post
  #28  
Old 11-19-2018, 11:40 AM
rohrt rohrt is offline
Ultimate Warrior
 
Join Date: May 2004
Location: Cedar Rapids, IA
Posts: 4,125
Default

Yeah I have some roller skate bearing I was thinking of using to make the end former but the vice and a hammer work fine for me.

My hinge cover is what the aftermarket sell. Yes I dyed mine to match. Mine have never been used yet so you get what you get. Thanks for that link. I'm going to dig into that more. If they sell that pin with the covers they must sell that alone to. To bad OPG didn't sell them together.

very interesting link. I had no idea that this seat back part was ever made separate. Funny thing is the part is upside down in the pic. But that assembly is what I need the width dimensions on too. It looks like it slightly narrows at the bottom. I found a canada supplier that may still have them in stock. I may just go that route if it works out.
https://www.ecklerschevelle.com/chev...1964-1967.html


As for the seatbelts. I removed mine so the upholstery guy can put them in.