Quote:
Originally Posted by TCSGTO
Comp uses different vendors so the seat height probably depends who they sourced them from.
To accurately measure seat height you’d need a mic with a ball on one end that matched the end of the pushrod you’re using.
|
Yes, I can borrow a mic Monday to get a more accurate measurement.
How close do you think they would need to be, compared to what I have now?
Push rods usually come in .050 increments, I think.
If I can find lifters within .050 of the original Comps, would that be “close enough” you think?
This is in a pretty mild driver.
ETA, I am replacing all the lifters.
Thanks
Murf
Sent from my iPhone using Tapatalk Pro