Quote:
Originally Posted by mrennie
That is the right type of product, but that one is only rated up to 120*C which is 248*F. While your engine should not normally run that hot, I would look for something rated a bit higher, at least 300*F. The JB Weld I used was rated for 550*F
|
Good catch, and i agree i would like a little leway on temprature range.
I think i can get Permatex® Steel Weld™ Epoxy from a local supplyer.
__________________
Murphy's law - "Anything that can go wrong will go wrong".
-469 ,Butler 310+ Eheads, Hurricane intake portmatched by butler, Butler roller 230/236 @0.50 112 LSA, Johnson lifters, pypes 2 1/2" exhaust, 3.42 yukon duragrip lsd, holley sniper efi, hyperfuel efi tank +++
|