Thread: HLA Question
View Single Post
  #7  
Old 05-14-2020, 11:21 AM
63 bomb's Avatar
63 bomb 63 bomb is offline
Senior Member
 
Join Date: Mar 2020
Posts: 125
Default

Understood... Just to make sure that I don't have to pull the top end apart again, what's the procedure for the HLA installation? Take them out, pull out the pin in the top, depress the check valve and let them drain? Then install them with nothing more than a coat of oil on them? After that, re-assemble the top end, fill the oil pan, pull the distributor and run with a drill until I've got oil pressure before firing? Sorry for all of the questions, but this is nothing like any other engine I've built in the past. Thanks again guys.