View Single Post
  #5  
Old 09-07-2019, 09:20 PM
GregM329 GregM329 is offline
Junior Member
 
Join Date: Jan 2016
Location: Vero Beach, Florida
Posts: 22
Default

I am currently in "Motor Mount Hell" with my '79 TA. The pictures on this thread from March verified that I am currently using the correct holes, but my frame mount pin holes aren't lining up with my engine brackets. When I put it together wrong (using upper holes on one side), the spacing was 15 13/16" (center to center) and the pins went in, but engine sat at a 3 degree angle. Now, using the correct holes, the spacing is 15 1/4" and the pins aren't going to go.

Can anybody verify what the correct distance between the frame mount pin holes is supposed to be?

I'm using Ames FN621B engine mount brackets on the engine. I hope Ames will be able to help on Monday, but that doesn't do me any good on a Saturday night.

It would seem that if I am using the correct holes, it's either the frame mounts or the brackets are wrong.