[HWYSTR455]

Yeah, sorry, busy as all at the moment, lots going on. Anyway, so Saturday I got the ignition all setup and installed, dizzy, plug wires, looms, and was going to do the O2 sensor which I ordered from Summit on eGay. So opened the box, pulled it out, and the bag it was shipped in was open, and when I pulled it out, there was carbon on the tip, so it appears as if it's used. Bummer. It's a NTK one, the $275 variety, so going to send it back and get a 'new' one. (Didn't want to install a used one, period). Long story short, no startup this weekend.

Basically, all that's left to do for the start up is exhaust clamps, add gas, and verify the ECU config.

But I did get some shots on the plug wires, and the looms installed. Just a recap, running the PRW type valve covers, and the bolts go in thru the top rail of the covers, and are recessed. Makes it difficult to do wire looms, but used some Moroso BBC ones and it looks good, will do the trick.

The 90 degree brackets I had to bend to make work, and used Moroso regular clip on separators along with the bracket-type looms. There's a close up of one of the bent brackets to give you an idea.

Pics:


.