Thread: Pinion angle
View Single Post
  #21  
Old 05-22-2020, 06:58 AM
charlie66's Avatar
charlie66 charlie66 is offline
Ultimate Warrior
 
Join Date: Dec 2004
Posts: 3,261
Default

Quote:
Originally Posted by rod cole View Post
If it were mine at 3,89 down on trans I would start at 2 dgrees up at the rear end pointing up . again the driveshaft angle is whatever it ends up at once you acheive parallel. .My car the rear yoke is considerable higher than trans so the angle on the shaft is wonky but runs smooth to 125 mph
That really cleared this up for me rod. Thanks for the video. He said to match the angle with the input and out put . Thats the part that gets me alittle confused. Because right now the rear is at 0 and the trans is at 3.85. Would turning the rear to 3.85 be the way to go because at 2 up im still 1.85 away from a match right? He said with in 1 degree..

__________________
My Half AN Injun.....