[JUDGE3]

Thank you HWYSTR455

Passenger side all welded on. still have to go back over the weld and fine tune em but want to move on to the drivers side and get it to the same point.

I did get some warping as hard as I tried not to. but its my first quarter install. also as tight as I had it fitting, learned you don't want it that tight I don't think. I didn't take into account how the panel changes via expansion so I actually had to use the cutting wheel and open the gap up more as I went in a few areas.

after the drivers side is on, i'll do some hammer/dolly/stretching work and see how that works in the warp areas. experts please chime in on that would like to hear advice on that.