Next, measure and cut your cover listing rods, using the channels in the bun as a guide.
Make your reference marks where you plan to hogring the cover through the bun (on both sides), then use your box knife (with a fresh sharp blade) to cut the slits, and make sure you can grab the spring side paper covered listing rod under the burlap.
Pull your cover inside out, then lay it out over the bun.
Take a look at the sides- See those little reference snips, just like on your original cover. They help you to ID top to bottom placement of the cover. Arrange it so those marks are just above and just below the metal tabs in the side of the frame.
Take a look at the top- it also has a little reference snip ID'ing the centerline of the center pattern.
Line it up with your reference mark at the top of the bun.
The bottom of this cover did not have the reference snip in the center- So i just measureed and marked it... Line it up at the bottom of the bun.
The cover is now in position
|