[rambow]

The whole point of this thread was to try and show how this can be done by anyone if they know the right steps.

The upholstery for these cars was installed on an assembly line (yes, GM's Trim shop's also used assembly lines).
One guy standing there doing the same part of this puzzle over and over and over again. Then the next guy doing his part, and the next until they were done.

There is no magic here- but there is a process behind each step, and I've tried to show at least my interpretation of how its done.

There are dozens of ways to skin these particular cats- and I am always learning new tricks from others too.

So if you are a person who enjoys being able to say they have done EVERYTHING to restore their own car... GIVE THIS A TRY- YOU CAN DO IT.

Anyway- I'm happy to answer any questions anyone might have...
If anyone is looking for any of the supplies used in this build (new springs, custom wire bending, installation kit materials) Feel free to PM me.

Cheers!
Ben