So I followed the suggestions offered here and was able to ‘save’ the harness by repairing it, but I think this was a temporary fix. I wasn’t able to solder the thick red wire. I’m new to doing electrical work but no matter how long I held the soldering gun on the wire, it never got hot enough for the solder to melt. I was holding the soldering gun tip at the bottom of the spliced wire (I think that’s correct way) and then touching solder to top of splice. I thought it was supposed to wick through but nothing happened. I know the gun was hot enough because if I touched the solder to the tip of the gun, that melted it. Any suggestions?
Sent from my iPhone using Tapatalk
__________________
Three times the sound peaks, falls back, peaks again. A throttling back to cruising speed, a dwindling grumble of thunder and...gone.
The frogs take up where they left off.
|