View Single Post
  #24  
Old 10-05-2019, 07:55 AM
Half-Inch Stud's Avatar
Half-Inch Stud Half-Inch Stud is offline
Ultimate Warrior
 
Join Date: Jul 2000
Location: BlueBell, PA or AL U.S.A.
Posts: 18,457
Default

those Q-JET casting colors look just fine.

Replace/renew the sheet metal Choke crap, and wire-brush then clearcoat the Driver side linkages, and be done.

Slap it on and diagnose the;

Idle, and warmup choke setting (fast-idle) to kick down nicely.
the Part-Throttle Choke Pull-Off ability (to not bog).
the Secondary Rods mixture for HP ( go to Thin tips to start-out Rich, and then lean out to you satisfaction).

Only worry is Fuel needle-seat which can be handled anytime; goal is to reach using a 0.135" dia seat hole.

You only need an "Expert" if your Engine Vacuum is low due to. huge cam.


Last edited by Half-Inch Stud; 10-05-2019 at 08:34 AM.