Well did the trunk adjustment today best possible it's kinda wide at the top on the pass side but if I move it to take up the gap on the upper right the lower left get too tight for my liking...I can live with it....it better than it was before
Found my first sign of filler drivers door no big dents just some small stuff...
Also cleaned the jambs up and then I'll do the doors..but not doing all of it just wanna do the outer area of the door up to the seal area ...
I also did the door pins in the pass door today...pain in the arse to do cause I couldn't get the door open enough to get the upper hinge out..so I had to loosen the lower hinge and finagal it out then adjust the door...
So I've got the hood to do...both fenders lower Valance and tail filler panel
...oh and the rear spoiler so think I'm doing ok for end of November ....
__________________
1973 Firebird Navajo Orange w/shaker,1973 400/461,1972 Intake SD CNC'd,1977 Q-Jet 800 CFM w/ Cliffs Kit,Tanks Inc PA4 255 Walbro intank pump ,-8an feed/return,RobbMc Regulator,RobbMc 40 micron filter,253 CFM 6x-8's w/H.S 1:5 Roller Rockers,SD Stump Puller H/R Cam 230/236 @.050 112 lobe separation 565/.570 lift,Crower Solid Rollers,28150 Hedman Headers,3" exhaust,full tailpipes,350 Turbo,9.5" 3200 Converter,3:42 gear,8.5 posi,C/E slide-alinks,Koni adj frt shocks,Best 12.18@110.55 Lookin for 11's
Last edited by cnc; 10-12-2020 at 06:53 PM.
|