Quote:
Originally Posted by wbnapier
"A" - Is the brown wire that goes to #9 engine harness bulkhead connector. I think that goes to the external voltage regulator that I am not using, so I can try to make a terminal for that.
|
Brown wire that went to the old voltage regulator is for the GEN/ALT light.
This wire should go to terminal #1 on the new alternator.
With MSD box, this light wire will need a diode to stop the run-on problem.
Page #8 here in MSD instructions.
https://www.jegs.com/InstallationIns...1/121-6420.pdf
Clay