Quote:
Originally Posted by Blue '66
Bart is there a reason why you didn't put the fuel line inside the frame?It was a B%tch but I did it,I had to use a rubber grommet where the line comes out because the line almost touches the top of the opening.
I used those bodymounts also.Any problems with squeeks?
|
The goofy fuel line routing was done due to my engine choice. The LS3 fuel rail inlet is up high on the driver's side, hence the 'incorrect' fuel line routing.
Not sure about body mount squeaks on this car, have not driven it yet as it's a long ongoing project at this point. I have the same mounts in my GTO, but there is no floor insulation or carpet and a loud exhaust system. I can't hear them squeaking, but the mechanical noise level is a bit high inside the car.
