Fuel gauge issue
Thanks Clay! I think you nailed it.
Un-plug sending unit wire, ground it and see if guage goes to empty.
Does not go to empty
Ohm test sending unit wire from tank to check fuel level and see if sender is working. Yes reads 76 ohms which is accurate for fuel in tank
Ohm testing back of guage gives reading on resistors inside of it. 0 ohms with sender wire disconnected
Still 0 ohms with sender wire connected
I have brand new harnesses from gas sender including the Mylar PCB. I’m suspecting the connection at the PCB or even the PCB itself?
|