Right now all the bushing on the entire car are just hand tight, no shims up front, and those bolts are not tight either, all rubber everywhere. Again I dread crawling around wrenching on all those bushings, front and rear ... without jacking up the car.
Last night I actually pulled off the re-pop sway bar struts and replaced them with Moog parts (rubber actually made in USA). Rubber bushings in the re-pop was already cracking after being installed for about three years. Also used the Moog hardware, bolt is 1/16" larger OD, washers are not pressed garbage .... that "go-to" "correct" re-pop front suspension stuff is just plain horrible garbage ... I'll just have to live with the fact that now it only looks 90% correct