My orignal looked decent until I bead blasted the paint. Ventilated it around some of the seams. I used JB weld from the outside & figured it would not be visible from the way its mounted, but I kept chasing little pinholes & I gave up. Not sure how you would get POR15 inside. The stuff is pretty thin, but that is a small vacuum port. Possibly a small funnel on a vacuum tube, then stick a wd40 straw through to let the air escape the container as it goes in? Might not be enough room to do that, but maybe?
__________________
68 GTO 4-spd Convertible
78 S/E Trans am L78, WS6 Auto
78 S/E Trans am W72, WS6 Auto
79 10th aniv W72 Trans am
80 Indy pace car Trans am
89 Trans am GTA
|