Quote:
Originally Posted by dataway
Well .... all I have is the standard pressed in plugs .... so the quarters might be an improvement over that.
|
I have had the standard pressed plugs for years. But what I did was take a square edged file and make some little cuts in the plug and take the handle of the file and make a few deep scratches in the block where the plug fits. I did this so the JB Weld would have more to "grab" that i smeared on the plug. Like where you sand something when you epoxy it.
Then I staked it on the inside lip with a punch then filled the rest with JB.
Its not coming out.
You can still tap it for pipe threads at a later dare if you chose.