Quote:
Originally Posted by Sirrotica
Just to give you a heads up, those block off plates will likely have holes burned in them within 500 miles of you installing them. Speaking from experience the metal is too thin to stand up to the exhaust heat. It takes stainless much thicker than those block off plates to stop the burn through for extended driving such as street use.
|
That is my understanding as well. If I were to attempt a solution, would adding a thin sheet of metal to the piece that comes with the Mr Gasket gaskets, maybe sticking the metal pieces together with the High Temp red silicone and then putting them in place where they normally go, with the "button" of the supplied metal piece centered in the hole of the gasket as designed work?
Or??
I don't want to fill in the heat port..yet..in case it causes more problems like Kenth suggested.