I usually start with the lower cushions...
Lay the bun on the seat and turn it so you are looking at the back.
fold the rear attaching cloth under the bun then center the rear of the bun between the metal frame and hogring it to the springs as shown.
Then turn the frame so you are looking at the front.
Tilt it up, the cushion should be positioned so the front corners of the spring assembly are poking into the front "pockets" in the bun.
Pull the front attaching cloth down in the center and hogring it to the frame.
Turn the frame to look at the side
fold/roll up the attaching clothes and pull the edges of the cushion down and around the sides- and hogring to the bottom of the spring assembly.
|