| FAQ |
| Members List |
| Social Groups |
| Calendar |
| Search |
| Today's Posts |
|
#1
07-29-2012, 02:20 PM
|
||||
|
||||
Emblem Help Needed
I'm rebadging the 64 from a Tempest Custom and putting GTO emblems on. I have looked everywhere for some measurments on where to place the emblems but no luck so I figured I'd ask you all for some help.
I'm doing the rear quarters, and the lower fender 6.5. Lets make this as easy as possible and it it doesn't have to be perfect to the 1/32" but close. Rear Quarter, measuring from the top of the body line that runs the length of the car, up to the bottom of the emblem. Then from the rear of the quarter. Just measure from the body line without the quarter extension to the middle of the emblem. Front fender- from the back edge of the fender to the middle of the emblem. From the top edge of the body line down to the top of the emblem. Thanks for the help, Dil
__________________
You know it's going to be a good day when you wake up breathing! |
|
#2
07-29-2012, 09:53 PM
|
||||
|
||||
|
|
|
#3
07-30-2012, 04:40 PM
|
|||
|
|||
|
__________________
John '68 Firebird Ram Air 4-spd Conv. John 14:6 Semper Fi 
|
|
#4
07-31-2012, 07:13 AM
|
||||
|
||||
|
The 64 Tempest 1/4 emblem hole pattern is the same as the GTO emblem pattern. But I am not sure if the location is the same.
Last edited by 64woodwheel; 07-31-2012 at 07:38 AM. |
|
#5
07-31-2012, 02:30 PM
|
||||
|
||||
|
Quote:
|
| Reply |
|
|
The PY Online Forums is the largest online gathering of Pontiac enthusiasts anywhere in the world. Founded in 1991, it was also the first online forum for people to gather and talk about their Pontiacs. Since then, it has become the mecca of Pontiac technical data and knowledge that no other place can surpass.
Linear Mode
