[Vid]

Very excited to be replacing my original forward lamp wiring harness, it should clear up a myriad of mystery issues that I’ve been dealing with. Been cleaning up and replacing ground wires throughout the chassis too.

95% of this job is super simple. However I’m sure there is a trick to removing the forward lamp harness boss from the firewall (behind the brake booster). Anybody here dealt with removing the block from the firewall lately? I found one article that says just pull it straight out from the firewall. Is that correct or is there a fastener holding it tight? I’m guessing there must be a screw or two hiding in the tar or whatever that gunk stuff is. It’s the block on the right in the photo. Thanks.


Sent from my iPhone using Tapatalk