FAQ |
Members List |
Social Groups |
Calendar |
Search |
Today's Posts |
|
Members Helping Members help Buying a non Pontiac item, transportation help, Handy-man advice, directions, vacation ideas, places to dine, ebay and generally anything you think might help other members. |
Reply |
|
Thread Tools | Display Modes |
#1
|
||||
|
||||
1990 Mazda vacuum diagram needed
I have a 1990 Mazda B2200 carbureted truck. I recently removed, rebuilt and reinstalled the engine. I need a diagram to sort the many vacuum lines. My Chiltons manual has a diagram that looks close, but it is labeled as a 2.6 diagram, my truck has the 2.2 engine, and it a little vague and hard to read in places.
I have looked unsuccesfully on the internet... I will try the library next... Does anyone know where to find a good "vacuum diagram" for a Mazda? Thanks! in advance...
__________________
1969 Firebird, Tx3-455/468 machined by CVMS E-heads by Dave Wilcox/Comp Cams 300B-6 flat solid 850DP on E-85 by Eric Niefert/T2 1" plastic spacer T-400/PTC 4000/390's/30x9 Hoosier radial slicks,#3400 1.38 60' 6.32 @ 108 MPH at Northeast Dragway NC 5/23/15 (9th pass on new engine) https://m.youtube.com/watch?v=ePCu2v...ature=youtu.be 1.37 60' 6.26 @ 109 half track, 9.86 @ 136 1/4 mile, #3350 11/26/16 at Richmond Dragway (125th pass on new engine) |
#2
|
||||
|
||||
Here you go. Good luck. Let me know if you need any other diagrams. They had 3 differant options, 2.2 carb, efi than 2.6. Hope this is better than what you had.
__________________
Illinois Outlaw Gassers 6.27@107 9.97@131 Last edited by Bill Eveland; 06-18-2007 at 01:14 PM. |
#3
|
||||
|
||||
Thanks Bill,
Thats the same one in my Chiltons manual, but the manual has it labeled as a"2.6 L engine". I figured it was a miss-print. I can enlarge the electronic version and see it more clearly, so it will help me. There is a large line not in this diagram, it comes out of the base of the manifold under the carb (between the carb and valve cover), but I have not figured out where it goes yet. Thanks again, and I will get to you back tomorrow after I try to get it right.
__________________
1969 Firebird, Tx3-455/468 machined by CVMS E-heads by Dave Wilcox/Comp Cams 300B-6 flat solid 850DP on E-85 by Eric Niefert/T2 1" plastic spacer T-400/PTC 4000/390's/30x9 Hoosier radial slicks,#3400 1.38 60' 6.32 @ 108 MPH at Northeast Dragway NC 5/23/15 (9th pass on new engine) https://m.youtube.com/watch?v=ePCu2v...ature=youtu.be 1.37 60' 6.26 @ 109 half track, 9.86 @ 136 1/4 mile, #3350 11/26/16 at Richmond Dragway (125th pass on new engine) |
Reply |
|
|