FAQ |
Members List |
Social Groups |
Calendar |
Search |
Today's Posts |
#1
|
|||
|
|||
64-67 frame section needed - rear bumper
My car was hit in the back - bent the bumper up into the tail panel and bent the back of the frame
Bent on the driver's side right after the boxing ends, so in the thin part - looks like the rest is good I was hoping to find a replacement piece that's in good shape - just cut and weld and replace I realize mine could maybe be straightened....but rather just replace, i think...shouldn't be hard to do Anyone have a solid piece? I've found a few locally, but were too pitted to deal with (Ohio area rust)
__________________
Clay Marsh 1967 GTO convertible Twin Turbo 5spd project http://forums.performanceyears.com/f...d.php?t=618281 http://www.youtube.com/watch?v=eJ9KworCMRE |
#2
|
|||
|
|||
Hey Baron,
Let me know if you can't find one, I have a Texas frame out back that is rust free from a 64. Problem with mine is that it is broke out around the upper control arm mounting points. So if I had to I could chop off the rear section although I am not too keen on that. Jeff
__________________
1964 GTO 389 Tri-Power 4-Speed !978 Corvette 25,000 original miles |
#3
|
|||
|
|||
sounds like exactly what i'm looking for - your rust free frame would be pretty solid
I looked at one locally i could get cheap but i could put my hand on it and almost bend it myself - that weak from Ohio rust wearing it down over the years I'm not too optimistic on finding better from a parts car around here
__________________
Clay Marsh 1967 GTO convertible Twin Turbo 5spd project http://forums.performanceyears.com/f...d.php?t=618281 http://www.youtube.com/watch?v=eJ9KworCMRE |
Reply |
|
|