| FAQ |
| Members List |
| Social Groups |
| Calendar |
| Search |
| Today's Posts |
|
#1
03-28-2010, 05:19 PM
|
||||
|
||||
Blower Motor Wire
This seems all too simple............but I can't figure it out.
The wire that runs along my firewall to the heater box blower motor is very brittle and I want to replace it. Trouble is I can't pull/twist/swear the connector off the blower motor - I imagine it can come off. What's the secret? LOL
__________________
"Listen to her why-ee-eye-ine......... Listen to her why-ee-eye-ine"  1965 GTO Post Coupe, Burgundy w/Parchment, 467, Crower 60243, Rhoads V-Max, Ported 5C's, JB Roller Rockers, Original '66 Tripower, Dave's Small-body HEI, RA Exh Manifolds, 2.5" Exh X-pipe w/Super Turbo's and SS Splitters, Tremec TKO 600, 3.91 12-Bolt Posi w/bearing retainers, boxed frame, 4X Discs with hydro-boost, EPAS |
|
#2
10-21-2014, 10:32 AM
|
|||
|
|||
|
Actually I would like to know the same thing, having the same issue.
|
|
#3
10-21-2014, 11:06 AM
|
|||
|
|||
|
For your 65 ? There is a spade terminal attached to the motor. Same blower motor GM used for 15 + years. Sounds like the terminal that slides on to it has seized. The terminal (female part) should have a rubber boot over it.
|
| Reply |
|
|
The PY Online Forums is the largest online gathering of Pontiac enthusiasts anywhere in the world. Founded in 1991, it was also the first online forum for people to gather and talk about their Pontiacs. Since then, it has become the mecca of Pontiac technical data and knowledge that no other place can surpass.
Linear Mode
