[TedRamAirII]

https://www.ebay.com/itm/1970-Pontia...Make%3APontiac

[400 Lemans]

http://forums.maxperformanceinc.com/...t=repro+intake

[dmac]

Not too bad a price if you need an intake anyway, or if you need it for matching. There are cheaper alternatives that may perform a little better, but there is the cool factor of original factory parts. I do see a lot of used Edelbrock intakes for $50-$100 if you use craigslist and just want a basic intake. Whether it is a good deal??? $400 isn't going to be far off from the best deal you will ever see, and it is available now. You MIGHT find one for $200, or get lucky and get one the seller doesn't realize is worth more, but they are pretty rare, so paying $400 for something you may never find for much less could be a great deal as long as it is a factory part and not a repro part.
Ames sells a repro version for less-
https://secure.amesperf.com/qilan/De...A&web_access=Y

[TedRamAirII]

Originally Posted by dmac

Not too bad a price if you need an intake anyway, or if you need it for matching. There are cheaper alternatives that may perform a little better, but there is the cool factor of original factory parts. I do see a lot of used Edelbrock intakes for $50-$100 if you use craigslist and just want a basic intake. Whether it is a good deal??? $400 isn't going to be far off from the best deal you will ever see, and it is available now. You MIGHT find one for $200, or get lucky and get one the seller doesn't realize is worth more, but they are pretty rare, so paying $400 for something you may never find for much less could be a great deal as long as it is a factory part and not a repro part.
Ames sells a repro version for less-
https://secure.amesperf.com/qilan/De...A&web_access=Y

Looks like a deal. Intake WITH Crossover. If I needed one, I would sure jump on it. ; )....onthe other hand, its not BUY NOW its "opening bid".

[Half-Inch Stud]

Seems to be a bargain with the Exhaust crossover.

[PAUL K]

FWIW.....that's not the "ported" version that The Parts Place offers. It looks like someone may have gasket matched the runners, or atleast one runner.

[Blued and Painted]

Subscribe
I think it goes ? 1K.

[The Boss]

Guys....that intake is a repop.

The reproductions were based on the 72 intake and have the raised boss on #6 runner that the original didn't have. Part number is in the wrong location, wrong size, machined area around the water neck is too large, etc. etc..

This is what a real one looks like.

[74Grandville]

you can also tell by the thermostat housing pad. last i checked repops went for $400, so not a deal.

[TedRamAirII]

Originally Posted by 74Grandville

you can also tell by the thermostat housing pad. last i checked repops went for $400, so not a deal.

$400 with a crossover isn't a deal? So your repop comes with a crossover? Who?
Where?

[78w72]

definitely a repro, he says he just recently bought it new.. & as mentioned its opening bid so you might get it for that price or it could get bid up. & its plus $30 shipping.

the parts place sells theirs with crossover for $499 free shipping. so in the end its about the same give or take the difference more bids might do.

& i think the repros are cast with the shallower intake plenum like the SR factory replacements. these are a decent intake but you can get better performance from a cheaper torker2, street dominator or rpm etc.