| FAQ |
| Members List |
| Social Groups |
| Calendar |
| Search |
| Today's Posts |
|
#1
01-20-2019, 07:29 PM
|
||||
|
||||
Pulley photos
LookMy bottom crank pulley is half a groove too shallow. It needs to come out about a half groove. When I pulled the engine I let timing cover and pulleys go with it except for the alternator braket. So I'm wondering if I don't need a different pulley. Any help would be appreciated.
These photos are of the crank pulley I have now. Last edited by hobbygto65; 01-20-2019 at 07:57 PM. |
|
#2
01-20-2019, 07:52 PM
|
|||
|
|||
|
What timing cover and pulleys are you running now,what did they come off of?Tom
|
|
#3
01-20-2019, 08:00 PM
|
||||
|
||||
|
The alternator and bracket is original, so I know that's right. I have same one on my Cat. Timing change cover and balancer are 1966. The alternator and water pump pulleys line up.
|
|
#4
01-20-2019, 08:33 PM
|
|||
|
|||
|
the 63s V8 tempest came with 4 bolt timing covers early and 8 bolt later.Do you remember which you had?You will need the 63 lower pulley .Dave Johnson might be able to help with it.He is on this board.Tom
|
|
#5
01-20-2019, 08:55 PM
|
||||
|
||||
|
It had the 4 bolt water pump cover but it has 66 eight bolt cover now.
|
|
#6
01-20-2019, 10:01 PM
|
||||
|
||||
|
I think I'm going to have a 3/8" spacer made to go behind the pulley, that should line it up.
|
|
#7
01-28-2019, 11:27 PM
|
||||
|
||||
|
I have a zillion pulleys including 63's. Do you know the P/N of what you need?
|
|
#8
01-29-2019, 03:30 AM
|
||||
|
||||
|
Don't know the part number. Got a 1/4 inch spacer and now it lines up perfectly, so I'm good. Thanks.
|
| Reply |
|
|
The PY Online Forums is the largest online gathering of Pontiac enthusiasts anywhere in the world. Founded in 1991, it was also the first online forum for people to gather and talk about their Pontiacs. Since then, it has become the mecca of Pontiac technical data and knowledge that no other place can surpass.
Linear Mode
