| FAQ |
| Members List |
| Social Groups |
| Calendar |
| Search |
| Today's Posts |
|
#1
08-20-2018, 04:14 PM
|
||||
|
||||
Carpet install?
Posted this on the interior section, but thought some of you may have had experience...
I found procedures online for cutting the L around seat bracket's, but how about the large pad for rear seat bracket that houses the seat belt retractor? The rear outside seat bracket on the 73 A-body sits on top of the seat belt retractor, which is mounted to the floor. What is the proper way to cut carpet around this piece? Thank you! Sent from my XT1585 using Tapatalk
__________________
68 Firebird-- Street/Strip - 400/461 Eagle Forged Bottom End & Ross Flat top pistons. KRE 325 CFM D port, Ultradyne 263/271 @.050, .4267 lift. Crower Solid roller lifters and 1.65 stainless rockers. Quickfuel 1000 on Torker2 intake and 2" open spacer. Hedman 1.75" headers. TH400 w/brake. Ford 9" w/3.80 gears & 28x9 Hoosier pro bracket drag radial. Best ET: 1.35 60ft, 6.29 @ 107.20 mph, 9.99 @132.33 mph. 3,300 race weight |
|
#2
08-20-2018, 11:26 PM
|
|||
|
|||
|
I poked a hole in the carpet where the bolt goes and used a razor blade to cut out a square big enough for the bolt to go through. Might not be the correct way, but it works and you can't see anything when it's all bolted up.
|
|
#3
08-21-2018, 09:09 AM
|
|||
|
|||
|
I did the same as cdrookie (although my car is a 77).
|
| Reply |
| Thread Tools | |
| Display Modes | |
|
|
The PY Online Forums is the largest online gathering of Pontiac enthusiasts anywhere in the world. Founded in 1991, it was also the first online forum for people to gather and talk about their Pontiacs. Since then, it has become the mecca of Pontiac technical data and knowledge that no other place can surpass.
Linear Mode
