FAQ |
Members List |
Social Groups |
Calendar |
Search |
Today's Posts |
#5641
|
||||
|
||||
Canadian speedos were MPH in those days...fyi
Nice car but only for the rich...good luck
__________________
Esquire '74 T/A 455 Y-code SD clone previously on Dawson's Creek: '74 T/A 400 '81 AMC SX/4 '69 FB 350 |
#5642
|
|||
|
|||
Ebay '73 SD
KAINSEL, Block appears correct but it's not numbers matching for all components across the board. Carb not correct. Carb float bowl assembly is for an auto '74 SD. Carb air horn assembly doesn't have the correct slanted vent. Secondary valves in the air horn assembly aren't correct. Distributor isn't correct. No idea on the transmission as there are no pics that I saw. Late production '73 SD....a rare car for sure.
|
#5643
|
||||
|
||||
eBay 2019. As this is a Canadian export car there is a very good chance it was once a victim of significant rust. Needs a closer look for sure.
__________________
"Spend all your time and money on that Pontiac GTO pile" - The Go-Gos, 1981 |
The Following User Says Thank You to starlightblack For This Useful Post: | ||
#5644
|
||||
|
||||
Canadian export 2V87X3N145319 is back again, now on the docket at BJ in January...
__________________
"Spend all your time and money on that Pontiac GTO pile" - The Go-Gos, 1981 |
#5645
|
||||
|
||||
Great, color combo!
|
#5646
|
|||
|
|||
Sold $159,500. Quite a bit higher than 2019 listing
|
#5647
|
||||
|
||||
Does anyone know if the rear driver side valve cover bolt closest to the intake manifold has a clip attached to it? If it does is the clip hole for it on the right or left of the bolt? Were there 3 clips per side?
Thanks SD73 |
#5648
|
|||
|
|||
Not sure if this applies to yours since you're asking specifically about a '73 but on my '74 SD (mostly original), which I'm assuming would be similar there is no plastic push pin clip in that metal bracket hole which btw is on the left side (toward front of car) of the valve cover bolt. (see pic) The frontmost metal bracket hole on that side has a metal clip that holds the taped electrical wire bundle. Interestingly, there is a metal bracket beneath each of the 8 valve cover bolts. A plastic push pin clip is only on the front left bracket (temp sensor wire) and on the rear passenger side bracket (TCS wire). It's very possible that most of the other metal brackets had a plastic push pin clip for some of the emissions related hoses and perhaps a spark plug wire holder but they were not on my car when I purchased it from the original owner back in '77. Hope that helps somewhat.
|
Reply |
|
|