FAQ |
Members List |
Social Groups |
Calendar |
Search |
Today's Posts |
#1
|
||||
|
||||
4L80 Mech Speed Tail Cups
The Mech Speedo Tail Cups are available as Custom castings for $600 +/- $75 from the Internets.
I'm in process with modifying 2 4L80 Tail cups to include the TH400 Mech Speedo port by welding an aluminum tube into the casting. Will soon have a cost base. Is there interest in me making more (modifying your part)? Can also drill PMD Flexplates for the 6-bolt Factory 4L80E Converter. Post or PM if interested. HIS |
#2
|
||||
|
||||
YES...hell yes.
|
#3
|
||||
|
||||
Subscribed.......
|
#4
|
|||
|
|||
I've seen this tried and still have one made this way. Good luck with keeping it from leaking.
If you need any 4L80E tailhousings, I have a surplus of them I will sell.
__________________
www.jakesperformance.com Racing Automatics and LSx Engine components |
#5
|
||||
|
||||
Quote:
Down the road, I hope to need tail housings to help a few fellas out. HIS |
#6
|
||||
|
||||
Slow yet steady. Have 2 Tail Cups done with MECH Speedo. Will Post pictures soon.
If interested; PM me or just send me your Tailcup & $290, I'll get it modified & send it back. Bead-Blast (for good welds), New Rear Bushing & Rear Seal. I can leave it bare or paint it gray (my usual finish). If you need a basic 4L80e core Tail Cup, see Jake's Post above. I have only 1 extra. |
#7
|
||||
|
||||
Trying for 3 photos; Shows clip to hold speedo insert.
Last edited by Half-Inch Stud; 11-30-2013 at 08:58 AM. |
#8
|
||||
|
||||
4L80 Tail cup
...turned over.
Last edited by Half-Inch Stud; 11-30-2013 at 08:58 AM. |
#9
|
||||
|
||||
another view of 4L80 mech speedo
third photo; shows clips holding the speedo in.
These mods were performed on unprepped cups. So the welds are nice but not perfect (like Marcella's work). These will get my gray paint to match the cases. The welder says that the glass bead prep will allow neat & uniform welds. Future mods will get the process: glass bead, Rear Seal & Bushing removed, cut & weld, clean, Install New Rear Bushing & Seal. either bare or gray paint finish. Last edited by Half-Inch Stud; 11-30-2013 at 09:05 AM. |
#10
|
|||
|
|||
Quote:
Do you supply the gearsets, and are they from a th4oo ? |
Reply |
|
|