| FAQ |
| Members List |
| Social Groups |
| Calendar |
| Search |
| Today's Posts |
|
#1
03-07-2012, 12:12 PM
|
||||
|
||||
67 dash pad studs and nuts
I have a dash pad I plan to re-dye and use in my car, but I can't seem to remove a nut on one of the studs...the nut just spins at the bottom and won't catch a thread even if I pull up on it. I've snapped a stud on one of these before, and don't want that to happen on this one because the pad is in perfect shape. Any trick to doing this or is it even necessary to remove the nut when installing the dash pad?
__________________
"If the best Mustang is the Camaro, the best Camaro is actually the Firebird" David Zenlea |
|
#2
03-07-2012, 12:40 PM
|
||||
|
||||
|
Are you describing the sheet-metal-type nuts on the pad studs that are used in the glove box area?
George
__________________
"...out to my ol'55, I pulled away slowly, feeling so holy, god knows i was feeling alive"....written by Tom Wait from the Eagles' Live From The Forum |
|
#3
03-07-2012, 12:42 PM
|
||||
|
||||
|
Yes
__________________
"If the best Mustang is the Camaro, the best Camaro is actually the Firebird" David Zenlea |
|
#4
03-07-2012, 12:48 PM
|
||||
|
||||
|
I'd cut the nut itself off with a Dremel tool.
|
| Reply |
|
|
The PY Online Forums is the largest online gathering of Pontiac enthusiasts anywhere in the world. Founded in 1991, it was also the first online forum for people to gather and talk about their Pontiacs. Since then, it has become the mecca of Pontiac technical data and knowledge that no other place can surpass.
Linear Mode
