FAQ |
Members List |
Social Groups |
Calendar |
Search |
Today's Posts |
#1
|
||||
|
||||
KRE Super Wedge Heads
Since these have been out for well over 2 years. Does anyone have any flow numbers stock or ported? Since i believe they come stock with a 2.25" intake valve and 1.8" exhaust valve. Does anyone know what the valve center's is?
Stan
__________________
Stan Weiss/World Wide Enterprises Offering Performance Software Since 1987 http://www.magneticlynx.com/carfor/carfor.htm David Vizard & Stan Weiss' IOP / Flow / Induction Optimization - Cam Selection Software http://www.magneticlynx.com/DV Download FREE 14 Trial IOP / Flow Software http://www.magneticlynx.com/DV/Flow_..._Day_Trial.php Pontiac Pump Gas List http://www.magneticlynx.com/carfor/pont_gas.htm Using PMD Block and Heads List http://www.magneticlynx.com/carfor/pont_pmd.htm |
#2
|
||||
|
||||
Heck I'd like any info Lol last time I was on their site they weren't even mentioned.
|
#3
|
|||
|
|||
KRE is doing a new port right now (470-480ish). It will be a few weeks. Been on the back burner for awhile.
|
#4
|
||||
|
||||
They made 950-ish HP unported.
|
#5
|
|||
|
|||
What C.I. .. what intake etc ...?
|
#6
|
|||
|
|||
I caught KRE s post the other day on Facebook sporting a Hemi piston and questioned where their advertising for this new Hemi engine is. Heck I even asked if they were going to let out any info in regards to the Super Wedges that have been around, what a couple years now if I m correct. I guess they like to keep things closed door from the haters. Their response was they rather not hype their products until final results lend it. I wasn t looking at a brag session just some general info like their out dated site has for their other products. Guess these new parts just aren t ready to be marketed yet.
|
The Following User Says Thank You to bluegoat65 For This Useful Post: | ||
#7
|
||||
|
||||
It is on their FB page. You can't search so you have scroll through the posts to find it. IIRC- it was from over the summer 2019 or a little earlier in the year.
|
#8
|
||||
|
||||
I found this from 2017 - 541 ci 50 mm cam stock / as cast super wedge heads 1150 dominator 926.8 HP @ 6900 rpm and 777.4 torque @ 5300 rpm. The dual 4 1050 dominators 937.8 HP @ 7000 and 785.9 torque @ 5800
https://www.youtube.com/watch?v=yT9LNO8TOOM https://www.youtube.com/watch?v=GYtTH7C3wAg
__________________
Stan Weiss/World Wide Enterprises Offering Performance Software Since 1987 http://www.magneticlynx.com/carfor/carfor.htm David Vizard & Stan Weiss' IOP / Flow / Induction Optimization - Cam Selection Software http://www.magneticlynx.com/DV Download FREE 14 Trial IOP / Flow Software http://www.magneticlynx.com/DV/Flow_..._Day_Trial.php Pontiac Pump Gas List http://www.magneticlynx.com/carfor/pont_gas.htm Using PMD Block and Heads List http://www.magneticlynx.com/carfor/pont_pmd.htm |
Reply |
Thread Tools | |
Display Modes | |
|
|