#1  
Old 03-04-2019, 11:40 AM
2+2=421 2+2=421 is offline
Member
 
Join Date: Feb 2005
Location: florida
Posts: 78
Default Repro parts place aluminum tripower 66 manifold

Has anybody use this manifold? I have heat cracks in the lowers plenum floor as well as down the side of the center carburetor bore and across the top between the throttle bores. so I have to try something different? They have been making them long enough I would assume the quality is good and the fit is good but can’t find anything on this tripower site talking about it in the last couple years.. are the 2018/19 units well done? Anyone?


Last edited by 2+2=421; 03-04-2019 at 12:19 PM.
  #2  
Old 03-05-2019, 06:05 PM
Red GTO 66's Avatar
Red GTO 66 Red GTO 66 is offline
Junior Member
 
Join Date: May 2003
Posts: 23
Default

I bought one two months a go from The Pontiac Tripower team it looks ok some port alignment work is needed and some rough edges smoothed in the plenum area.
Have not try it out on a engine for fit
But it look like it will work.

http://www.pontiactripower.com/catalog/1966-tripower


Last edited by Red GTO 66; 03-05-2019 at 06:10 PM.
Reply

Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -4. The time now is 11:27 AM.

 

About Us

The PY Online Forums is the largest online gathering of Pontiac enthusiasts anywhere in the world. Founded in 1991, it was also the first online forum for people to gather and talk about their Pontiacs. Since then, it has become the mecca of Pontiac technical data and knowledge that no other place can surpass.

 




Copyright © 2017