| FAQ |
| Members List |
| Social Groups |
| Calendar |
| Search |
| Today's Posts |
|
#1
09-15-2024, 01:24 PM
|
|||
|
|||
Wheel arch moulding fitment
Is there a trick to getting a better fit on the rear wheel opening trims? I have factory trims and factory quarterpanels. But it is hard to get the middle top tight to the body ! I have a noticeable gap. When I force the moulding tight, I have buckling of the flat part, like it needs shrinking. I am wondering if bending the wheel lip up or down will help? Or just cut a tiny pie section out of the trim?
|
| Thread Tools | |
| Display Modes | |
|
|
The PY Online Forums is the largest online gathering of Pontiac enthusiasts anywhere in the world. Founded in 1991, it was also the first online forum for people to gather and talk about their Pontiacs. Since then, it has become the mecca of Pontiac technical data and knowledge that no other place can surpass.
Threaded Mode