FAQ |
Members List |
Social Groups |
Calendar |
Search |
Today's Posts |
#21
|
|||
|
|||
I've only seen R or L on original rear calipers.
__________________
Steve F. |
#22
|
||||
|
||||
I will see if I can get some pics to post...
|
#23
|
||||
|
||||
|
#24
|
|||
|
|||
Little Help
Read the whole article twice
Where does the classic industries tool go?? |
#25
|
|||
|
|||
Little Help
Read the whole article twice do not get it yet
Where does the classic industries tool go?? Does any one have a picture of installation?? Do you install this before bleeding front and rear brakes?? I am getting ready to rebuild the 4 disc calipers got the kits from ORielys had a nasty pull on the front caliper. My back E brakes cables are siezed I am going to replace them with the rebuild. |
#26
|
||||
|
||||
The tool goes under the master cylinder at the proportioning valve. Take the brown wire off and unscrew the switch and screw that in. Never heard of that tool until now.
__________________
" Is wearing a helmet illegal" Mike Kerr 1-29-09 |
Reply |
Thread Tools | |
Display Modes | |
|
|